DEK 2-Way Feed Chipper/Shredder Manuel du propriétaire télécharger pdf (Page 23)

54Z, 62Z

Z- BEAST

BEAST Finish Mower

Rev: Mar2011

Service Adjustments

DANGER: Before making any adjustments or servicing

your mower, make sure the mower is on level ground,

the blades are disengaged, the brake set, the key is

removed, the engine is off and the spark plug wires are

disconnected from the spark plugs to prevent

inadvertent starting. If maintenance or adjustments are

being performed after operation of the mower, allow

the unit to cool since heat build up could cause severe

burns.

Engine-to-Blade Belt Adjustment

1. Raise the deck cover and move the blade control

lever on the control console to the ON position.

2. With approximately 10 pounds of pressure, push

the clutch pulley to tighten the belt. The linkage

should stop approximately 1 inch before contacting

the stop bolt. If the belt moves within 0.5-inch of the

stop bolt, adjustment is necessary. Move the blade

control lever back to the OFF position.

DANGER

Stop Bolt

Turnbuckle

Locking nut

3. Loosen locking nut.

4. Rotate turnbuckle until desired tension is achieved

(approximately 1 inch from stop bolt).

5. Tighten locking nut when finished.

6. Close deck cover.

IMPORTANT! The mower belts are adjusted to ensure

the blades stop turning within 7 seconds of releasing

the blade control lever. If you are making any belt

adjustments whatsoever, for your safety and the

safety of others around you, you must ensure the belts

are re-adjusted to achieve this design specification.

Fuel Valve Location

Air Filter Location Fuel Fill Location

Battery

Fuel Filter Location

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30 31

Pas de commentaire

DEK 2-Way Feed Chipper/Shredder Manuel du propriétaire Page 23